Components AE03 and AE05 Bike Pedal Rebuild Kit

This rebuild kit is perfect for HT pedals. It comes with a variety of components, including (2) 1mm black washers, (2) dust seals, (2) IGUS DU bushings, (4) O - rings, (2) .4mm black washers, (2) .8mm positioning washers, (2) wear springs, (2) thrust bearings, (2) end caps, and (2) self - locking nuts (1 left, 1 right). Note that needle bearings are not included.

To use this bike pedal rebuild kit, first remove the old parts from your HT pedals. Then, carefully install each component in the kit in the correct order. Make sure to clean the pedal before installation. When using the pedals, avoid excessive force that could damage the new parts. For maintenance, regularly check the components for wear and tear. If you notice any parts starting to fail, replace them promptly. Also, keep the pedals clean and dry to prevent rust and corrosion.